Pick up Hitch Fitting Instructions
⦁ Remove all existing drawbars or hitches not required for the fitting of the new hitch.
⦁ Using a lifting mechanism present outside frame to back end of the tractor.
⦁ Place bolts in back plate ¾ way around PTO or tighten if necessary to align up the bolt holes underneath tractor (this may not always be required).
⦁ Insert bolts on the bottom plate of the hitch. It may be necessary to remove the drop base by removing the hinge pin in order to access the bolt holes.
⦁ Tighten all bolts securely and use Loctite or similar to secure bolts in place.
⦁ Refit drop base with hinge pin if removed earlier and secure with locking bolt supplied.
⦁ Fit top arm extensions (using top arm pin if provided).
⦁ Start tractor and raise lifting arms fully.
⦁ Attach lift link to top arm extensions and lift rod ends to drop base spigots.
⦁ Using a jack or lifting mechanism, lift up drop base so hooks are clear to open.
⦁ Adjust lift rods to fit required height so hooks will open.
⦁ Secure lift rods to the drop base spigot with cotter pin supplied.
⦁ Fit pull spring on hooks.
⦁ Fit cable or hydraulic cylinder for opening hooks and plug into the tractor.
⦁ Remove jack or lifting mechanism and lift hitch to ensure hitch is functioning correctly (if hitch does not unlatch adjust lift rods and try again).
⦁ Fit rubber buffer (the top of the rubber buffer may need to be trimmed as necessary to allow the hitch to open).
⦁ Grease all moving parts.
3690 hitch 
